OpenSwim Pro Care: Rinsing and Storing After Pool Swims
By Open-Ear & Bone Conduction Headphones | Shokz Official | Published: 2026-10-13
Category: Tips & Care
A step-by-step routine to rinse, dry, and store your OpenSwim Pro after swimming so pool water and chlorine don't shorten its life.
Quick answer
Rinse your OpenSwim Pro in fresh water immediately after every pool swim, then pat it dry and let it air dry fully before storing. This removes chlorine and salt that can degrade the waterproof seals and rubber coating over time. With consistent care, your headphones will stay comfortable and reliable for many swims.
Why pool water is harder on headphones than plain water
Chlorine, salt, and pool chemicals leave a residue that can dry on the surface and work into seams, buttons, and the rubberized coating. Even though the OpenSwim Pro is IP68 waterproof, that rating protects the internal components from water intrusion, not from long-term chemical exposure. Rinsing soon after swimming prevents residue from sitting on the surface where it can cause stiffness or discoloration. It also keeps the charging contacts clean so the magnetic charger connects properly every time.
What you need before you start
You don't need special equipment. A sink or a bottle of fresh water, a soft lint-free cloth, and a dry storage pouch or case are enough. Avoid soap, detergents, or alcohol wipes, which can leave their own residue or dry out rubber seals. If you swim in a chlorinated pool, plain tap water is fine for rinsing. If you swim in salt water, rinse a little longer to dissolve salt crystals that can form as the water evaporates.
Step-by-step OpenSwim Pro care routine
- Rinse immediately after your swim: Hold the headphones under a gentle stream of fresh water for 30 to 60 seconds. Focus on the buttons, the speaker pods, and the area around the charging contacts. Do not use a high-pressure spray, which can force water past seals. Common mistake: waiting until you get home. Chlorine starts drying within minutes, so rinse at the pool if you can.
- Pat dry with a soft cloth: Use a clean, lint-free cloth to gently blot excess water from the surface. Pay attention to the crevices around buttons and the speaker grilles. Do not rub aggressively or use a towel that sheds fibers. Checkpoint: if the cloth picks up any colored residue, that's a sign you waited too long to rinse. Rinse again with fresh water.
- Air dry completely before charging or storing: Place the headphones in a dry, well-ventilated spot and let them air dry for at least an hour. Do not use a hair dryer or heater, which can warp the rubber coating and damage internal components. Make sure the charging contacts are completely dry before connecting the charger. Common mistake: charging while wet. Moisture on the contacts can interfere with the magnetic connection or cause corrosion over time.
- Store in a dry, clean place: Once fully dry, store your OpenSwim Pro in a dry pouch or case. Avoid leaving them in a damp swim bag, a hot car, or direct sunlight for long periods. If you swim daily, consider a small mesh bag that lets air circulate. Checkpoint: if you smell chlorine or mustiness when you open your case, it's time to rinse the case or replace it.
Product facts
- OpenSwim Pro: Shokz OpenSwim Pro bone conduction headphones are built for open-ear listening with a secure fit. They combine Bluetooth V5.4 and MP3 storage, with IP68 waterproofing and up to 9-hour battery life plus quick charge. IP68 waterproofing means the headphones can handle pool and open-water swimming, but rinsing after each use keeps the seals and buttons free of chlorine residue. The dual Bluetooth and MP3 modes mean you can leave your phone behind and still listen, so you won't need to handle the headphones more than necessary after a swim.
